Acceleration of thermo-oxidative degradation of high-density polyethylene using oxidized polyethylene

Document Type : Original research

Authors

Department of Polymer Engineering, Science and Research Branch, Islamic Azad University, Tehran, Iran

Abstract

In the present study, the thermal oxidation behaviour of high-density polyethylene (HDPE) containing each of two types of oxidized polyethylene (OPE), one prepared using 500 ppm of iron (III) stearate as pro-oxidant and the other without the pro-oxidant, was investigated. Fourier-transform infrared spectroscopy (FTIR) showed that the carbonyl index of the HDPE increased from 1.03 to 6.37 upon the addition of 5.0 wt.% of OPE containing the pro-oxidant after 100 h of thermo-oxidative aging at 90°C. Moreover, it was observed that the rate of changes in retained tensile strength and retained elongation-at-break of the HDPE during the thermal oxidation increased in the presence of 5.0 wt.% of each type of OPE, especially, the one containing iron (III) stearate, which was consistent with the obtained data from gel content measurements. Lastly, the evolution in crystallinity of the film samples was monitored by density measurements as well as differential scanning calorimetry (DSC). It was revealed that the crystallinity of the tested films during thermo-oxidative degradation grows faster in the presence of OPE. Overall, the findings indicated that the utilization of OPE containing trace amounts of iron (III) stearate can accelerate the thermal oxidation of HDPE films and facilitate entering the final biodegradation stage, while resolving the need to use high concentrations of harmful heavy metal salts.

Keywords

References

  1. Xu F, Wang B, Yang D, Hao J, Qiao Y, Tian Y (2018) Thermal degradation of typical plastics under high heating rate conditions by Tg-FTIR: Pyrolysis behaviors and kinetic analysis. Energy Convers Manag 171: 1106-1115
  2. Liang Y, Tan Q, Song Q, Li J (2021) An analy­sis of the plastic waste trade and management in Asia. J Waste Manag 119: 242-253
  3. Moliner C, Badia J, Bosio B, Arato E, Kittikorn T, Strömberg E, Teruel-Juanes R, Ek M, Karlsson S, Ribes-Greus A (2018) Thermal and thermo-oxidative stability and kinetics of decomposition of PHBV/sisal composites. Chem Eng Commun 205: 226-237
  4. Da Costa JP, Nunes AR, Santos PS, Girao AV, Duarte AC, Rocha-Santos T (2018) Degrada­tion of polyethylene microplastics in seawater: Insights into the environmental degradation of polymers. J Environ Sci Health A 53: 866-875
  5. Kashani NSS, Gharavani F, Jaberi N, Tayouri MI, Maleki F, Khonakdar HA, Otadi M (2021) Influence of organoclay and nitroxylether on the rheological, thermal and flame-retardant proper­ties of co-continuous PP/Eva blends. Plast Rub­ber Compos 51: 306-315
  6. Fairbrother A, Hsueh H-C, Kim JH, Jacobs D, Perry L, Goodwin D, White C, Watson S, Sung LP (2019) Temperature and light intensity effects on photodegradation of high-density polyethyl­ene. Polym Degrad Stab 165: 153-160
  7. Jahanmardi R, Pourattar P, Soleimani H, Shohani N (2017) Effects of thymolphthalein on thermo-oxidative stability of high density polyethylene in melt and solid states. Iran J Chem Chem Eng 36: 39-48
  8. Kebritchi A, Nekoomansh M, Mohammadi F, Khonakdar HA (2018) Effect of microstructure of high density polyethylene on catalytic deg­radation: A comparison between nano clay and FCC. J Polym Environ 26: 1540-1549
  9. Shahvazian M, Ghaffari M, Azimi H, Jahan­mardi R (2012) Effects of multi-walled carbon nanotubes on flame retardation and thermal sta­bilization performance of phosphorus-containing flame retardants in polypropylene. Int Nano Lett 2: 1- 17
  10. Jahanmardi R, Assempour H (2008) Study on the effect of galbanic acid on photo-oxidative deg­radation of linear low density polyethylene (LL­DPE) films. e-Polymers 8: 156
  11. Bagheripour-Asl M, Jahanmardi R, Taher­mansouri H, Forghani E (2018) Evaluation of thymolphthalein-grafted graphene oxide as an antioxidant for polypropylene. Carbon Lett 25: 60-67
  12. Chen C, Wesson R, Collier J, Lo Y (1995) Studies of rigid poly (vinyl chloride) (PVC) compounds. Iv. Fusion characteristics and morphology analy­ses. J Appl Polym 58: 1107-1115
  13. Iqbal MZ, Abdala AA, Liberatore MW (2016) Synthesis and characterization of polyethylene/ oxidized polyethylene miscible blends and role of OPE as a viscosity control. J Appl Polym 133: 43521
  14. Durmuş A, Woo M, Kaşgöz A, Macosko CW, Tsapatsis M (2007) Intercalated linear low den­sity polyethylene (LLDPE)/clay nanocomposites prepared with oxidized polyethylene as a new type compatibilizer: Structural, mechanical and barrier properties. Eur Polym J 43: 3737-3749
  15. Aydemir B, Sezgi NA (2016) Pyrolysis of poly­ethylene over aluminum-incorporated mcm-41 catalyst. Chem Eng Commun 203: 635-641
  16. Cichy B, Kwiecień J, Piątkowska M, Kużdżał E, Gibas E, Rymarz G (2010) Polyolefin oxo-degradation accelerators–a new trend to promote environmental protection. Pol J Chem Technol 12: 44-52
  17. Su B, Cao Z-C, Shi Z-J (2015) Exploration of earth-abundant transition metals (Fe, Co, and Ni) as catalysts in unreactive chemical bond activa­tions. Acc Chem Res 48: 886-896
  18. Perton F, Cotin G, Kiefer C, Strub J-M, Cianfer­ani S, Greneche J-M, Parizel N, Heinrich B, Pi­chon B, Mertz D (2021) Iron stearate structures: An original tool for nanoparticles design. Inorg Chem 60: 12445-12456
  19. Zheng G, Xu X, Li B, Wu K, Yekeen TA, Huo X (2013) Association between lung function in school children and exposure to three transition metals from an e-waste recycling area. J Expo Sci Environ Epidemiol 23: 67-72
  20. Zawadiak J, Marek AA, Orlinska B, Stec Z (2010) Catalytic oxidation of polyethylene with oxygen under solid-state conditions. J Appl Polym 118: 1414-1420
  21. Feng J, Carpanese C, Fina A (2016) Thermal decomposition investigation of abs containing lewis- acid type metal salts. Polym Degrad Stab 129: 319-327
  22. Mohammadhosseini M, Jahanmardi R (2014) In­vestigating effect of ferric stearate on stabiliza­tion efficiency of a phenolic antioxidant during thermal oxidation of polyethylene. Iran Polym J 23: 801-807
  23. Yang R, Liu Y, Yu J, Wang K (2006) Thermal oxidation products and kinetics of polyethylene composites. Polym Degrad Stab 91: 1651-1657
  24. Roy P, Surekha P, Rajagopal C, Choudhary V (2007) Comparative effects of cobalt carbox­ylates on the thermo-oxidative degradation of LDPE films. J Appl Polym 103: 3758-3765
  25. Rudin A, Choi P (2013) Mechanical properties of polymer solids and liquids. In: The elements of polymer science & engineering, 3rd A Rudin, P Choi. Academic Press, Brooklyn (NY), 149- 229
  26. Mokarizadeh Haghighi Shirazi M, Khajouei-Ne­zhad M, Zebarjad SM, Ebrahimi R (2020) Evo­lution of the crystalline and amorphous phases of high-density polyethylene subjected to equal-channel angular pressing. Polym Bull 77: 1681- 1694
  27. Michalak M, Hakkarainen M, Albertsson AC (2016) Recycling oxidized model polyethyl­ene powder as a degradation enhancing filler for polyethylene/polycaprolactone blends. ACS Sustain Chem Eng 4: 129-135
  28. Li D, Zhou L, Wang X, He L, Yang X (2019) Effect of crystallinity of polyethylene with dif­ferent densities on breakdown strength and con­ductance property. Materials 12: 1746
  29. Chen J, Yan N (2013) Crystallization behavior of organo-nanoclay treated and untreated kraft fi­ber–HDPE composites. Compos B Eng 54: 180- 187
  30. Krehula LK, Katančić Z, Siročić AP, Hrnjak- Murgić Z (2014) Weathering of high-density polyethylene-wood plastic composites. J Wood Chem Technol 34: 39-54
  31. Abrusci C, Pablos JL, Marín I, Espí E, Corrales T, Catalina F (2013) Comparative effect of metal stearates as pro-oxidant additives on bacterial biodegradation of thermal- and photo-degraded low density polyethylene mulching films. Int Biodeterior Biodegradation 83: 25-32
  32. Moo-Tun NM, Valadez-González A, Uribe- Calderon JA (2018) Thermo-oxidative aging of low density polyethylene blown films in pres­ence of cellulose nanocrystals and a pro-oxidant additive. Polym Bull 75: 3149-3169
  33. Roy P, Surekha P, Rajagopal C, Chatterjee S, Choudhary V (2005) Effect of benzil and cobalt stearate on the aging of low-density polyethylene films. Polym Degrad Stab 90: 577-585
  34. Antunes MC, Agnelli JA, Babetto AS, Bonse BC, Bettini SH (2018) Correlating different tech­niques in the thermooxidative degradation moni­toring of high-density polyethylene containing pro-degradant and antioxidants. Polym Test 69: 182-187
  35. Antunes MC, Agnelli JA, Babetto AS, Bonse BC, Bettini SH (2017) Abiotic thermo-oxidative degradation of high density polyethylene: Effect of manganese stearate concentration. Polym De­grad Stab 143: 95-103
  36. Zhao L, Cao Z, Fang Z, Guo Z (2013) Influence of fullerene on the kinetics of thermal and ther­mo- oxidative degradation of high-density poly­ethylene by capturing free radicals. J Therm Anal Calorim 114: 1287-1294
  37. Aldas M, Valle V, Aguilar J, Pavon C, Santos R, Luna M (2021) Ionizing radiation as adjuvant for the abiotic degradation of plastic bags containing pro-oxidant additives. J Appl Polym 138: 49664
  38. De La Orden M, Montes J, Urreaga JM, Bento A, Ribeiro M, Pérez E, Cerrada ML (2015) Thermo and photo-oxidation of functionalized metallo­cene high density polyethylene: Effect of hydro­philic groups. Polym Degrad Stab 111: 78-88
  39. Souza PMS, Morales AR, Sanchez EMS, Mei LHI (2018) Study of PBAT photostabilization with ultraviolet absorber in combination with hindered amine light stabilizer and vitamin E, aiming mulching film application. J Polym Envi­ron 26: 3422-3436
  40. Shi X, Wang J, Stapf S, Mattea C, Li W, Yang Y (2011) Effects of thermo-oxidative aging on chain mobility, phase composition, and mechani­cal behavior of high-density polyethylene. Polym Eng Sci 51: 2171-2177
  41. Jose J, Nag A, Nando G (2014) Environmental ageing studies of impact modified waste poly­propylene. Iran Polym J 23: 619-636

Files

History

  • Receive Date: 09 December 2022
  • Revise Date: 27 March 2023
  • Accept Date: 31 March 2023
  • First Publish Date: 31 March 2023

Share

How to cite

Statistics